1. The operator must pass the technical training and obtain the qualification certificate before using the rail cutting machine.
2.Make sure to master the technical performance of the rail cutting machine, be familiar with the safety operation procedures, and use and operate the equipment correctly to ensure that the rail cutting machine runs in a good working condition.
3.The operator must wear safety protective equipment such as tight-fitting protective clothing, goggles and socks.
4. Before starting the electric rail saw machine, check whether the electrical switch, power plug, and power cord insulation are intact.
5. Select the thin-film grinding wheel that meets the requirements. Before installing the thin-film grinding wheel, first check whether the two sides of the thin-film grinding wheel are straight, and whether there are defects such as cracks, damage, and moisture.
6. When the rail cutting machine is turned on, no one is allowed in front of the machine. When working, the operator should operate on the side of the grinding wheel.
7. After the electric rail saw machine is started, it should idle for no less than 30 seconds, and then start the operation after confirming that there is no abnormality.
8. When cutting, the feed of the grinding wheel must depend on the weight of the machine, do not press down violently; the joystick should swing back and forth moderately; when the grinding wheel is clamped, gently swing the joystick and lift it up at the same time, if the grinding wheel has been Damaged, do not continue to use.
9. If the protective cover of the thin-film grinding wheel and the belt of the rail cutter is damaged, do not continue to use it.
10. If the rail saw machine fails during operation, the line should be withdrawn to eliminate the fault. The power should be cut off when repairing the electric rail cutter.
11. Do the maintenance and repair of the rail cutting machine as required, so that the rail cutting machine is in a good technical state. A faulty rail cutter should not be used for work.
12. When cutting the rail under the line, the rail should be stabilized to prevent the rail from tipping over or hurting people after being cut off.
13. In case of rain, do not use the electric rail cutting machine for emergency repair work.
14. It is strictly forbidden to use the wire tractor of this machine.
